HALTECH Elite 2000/2500 Terminated Harness for Nissan RB Twin Cam With CAS Har. and Series 2 (late) ignition type sub har.
€984.14
Tax included
The fastest and most cost-effective way to wire your race car or engine conversion! Simply connect a handful of labelled wires and this plug and Play product allows you to be up and running in just a few hours.
HALTECH Elite 2000/2500 Terminated Harness for Nissan RB Twin Cam With CAS Harness and Series 2 (late) ignition type sub harness
DESCRIPTION
SUITS: Nissan RB Twin Cam RB20/25/26 with Series 2 Coils (Ignitor built into coil).
INCLUDES: Nissan RB Twin Cam Terminated Harness, CAS Harness HT-130327, Series 2 Coil harness HT-130330, Connector Pack for auxiliary I/O, Quick Start Guide.
NOTES: Series 2 Coil harness HT-130330- Uses OEM Coils with inbuilt Ignitor
HARNESS OVERVIEW
The fastest and most cost-effective way to wire your race car or engine conversion! Simply connect a handful of labelled wires and this plug and Play product allows you to be up and running in just a few hours.
A simple Haltech Plug'n'Play product that allows you to be up and running in just a few hours.
The quick start guide will walk you through installation of the Haltech Plug'n'Play adaptor into your vehicle.
The guide is accompanied by the full ECU manual and Software located on the CD or USB key provided with the ECU to refer to while completing your installation and configuration.
R32/33 CAM Angle Sensor Breakout
HARNESS FEATURES
This harness when installed in conjunction with a Haltech Elite ECU opens the door to virtually limitless performance modification and tuning of your vehicle.
Fully programmable systems allow you to extract all the performance from your engine by delivering precisely the required amount of fuel and ignition timing that your engine requires for maximum output under all operating conditions.
Warning
All GMC Racing items that involve increases in power greater than those required by the highway code of the country of the user, are intended only for competitive use.
GMC Racing disclaims all liability for any use of the product contrary to national standards.
HT-141231
Here you can add custom original content(text, images, videos and more) for each product page.
HALTECH IO 12 Expander - 12 Channel (CAN ID - Box B)
DESCRIPTION
The Haltech IO Expander 12 allows the user the ability to increase the functionality of their Haltech ECU by using the Haltech CAN...
Haltech CAN Cable8 pin Black Tyco to 8 pin Black TycoLENGTH: 900mm (36")
DESCRIPTION
LENGTH: 600mm (24")
Warning
All GMC Racing items that involve increases in power greater than those required...
HALTECH 1/4" Open Tip Thermocouple
DESCRIPTION
1/4" Thermocouple 2.10m (82.5") long - Pre-terminated with Mini K Type connector to suit TCA 2 or 4 thermocouple amplifier.
LENGTH: 2.10m...
HALTECH Platinum PRO Plug-in ECUHonda S2000
DESCRIPTION
SUITS: Honda S2000 AP1 (00-04) and AP2 (05). Non DBW, manual transmission only.INCLUDES: Platinum PRO Direct Plug-in ECU, Plug and pins for...
Bosch - DBW Pedal Assembly
DESCRIPTION
SUITS: Nexus and Elite VCU's and ECU's that support Drive by Wire Throttle Control (DBW).
INCLUDES: DBW Pedal Assembly and matching connector and pin set...
HALTECH Elite 1500 + VW/Audi 1.8T AWP ONLY (2001-2006)Plug 'n' Play Adaptor Harness Kit
DESCRIPTION
SUITS: Plug 'n' Play replacement of the factory ECU for VW/Audi 1.8T AWP ONLY (2001-2006)...
HALTECH WB1 - Single Channel CAN O2 Wideband Controller Kit
DESCRIPTION
This product allows the user the ability to increase the functionality of their Haltech ECU by using the Haltech CAN...
HALTECH Pins only - Suit Fuses only in the 6 CircuitHaltech Fuse Box -Pack of 10
Warning
All GMC Racing items that involve increases in power greater than those required by the highway code of the...
HALTECH Elite 1500 + Mitsubishi EVO 4-8 (5 SPEED) Plug'n'Play Adaptor Harness Kit
DESCRIPTION
If you are using a factory harness and are after an easy ECU upgrade, take a look at Haltech...
HALTECH 1/4" Open Tip Thermocouple DESCRIPTIONLENGTH: 1/4 " 0.84m (33")SUITS: NA or Forced induction applications. Used with a Requires a TCA 2 or 4 thermocouple amplifier.INCLUDES: Mini K Type...
IO 12 Expander - 12 Channel withPlug & Pins Kit (CAN ID - Box A)
DESCRIPTION
The Haltech IO Expander 12 allows the user the ability to increase the functionality of their Haltech ECU by using...
HALTECH Plug and Pins Only - Matching Set of Deutsch DT-3 Connectors (DT06-3S + DT04-3P) - (13 Amp)
DESCRIPTION
INCLUDES: 1 x DT04-3P Connector, 1 x DT06-3S Connector, 2 x Wedge Locks to suit, 6 x...
Haltech CAN Cable8 pin White Tyco to 8 pin White TycoLENGTH: 150mm (6")
DESCRIPTION
LENGTH: 150mm (6")
Warning
All GMC Racing items that involve increases in power greater than those required by...